• ROOKIE CLASS cars will be limited to 300BHP
• OPEN CLASS cars will be limited to 350BHP

• ALL drivers MUST wear a Race Suit (Karting suits are permitted) and Fire Retardant Gloves

• ROAD tyres ONLY - MAX width 225

• Front Brake Light Strip must be fitted at top of windscreen

• 2L AFFF Foam Fire Extinguisher must be fitted within arms reach of driver

• Front and Rear Tow Straps must be fitted and properly secured

• STRICT 105db Noise Limit

• Headlights and taillights must be fitted in factory condition - Blanks may be used as long as they fill factory location and appropriate rear brake light is in place

• All bumpers and exterior panels must be fitted and in place over the entire weekend - We understand parts can come off in a bump but please refit ASAP where possible

• Bumper Support bars ARE required. They MUST attach directly to the chassis legs or inner wheel arch and be made from MAX 25mmx2.5mm Mild Steel, Aluminium or stainless tube. The width of the bars may NOT extend beyond the centre of the wheel looking from the front or the rear of the vehicle

• Rollcages for this season are not required, however are advised

• Any convertibles, soft tops, cabriolets or any vehicle with a removable roof will only be allowed on track if the following requirements are met:

Roll bars or hoops must be made in one piece without joints. Their construction must be smooth and even, without ripples or cracks. The vertical part of the main roll bar must be straight as possible to the interior contour of the bodyshell.

Rear back stays are to be mounted as close to the top of the main roll bar as possible. These must be manufactured from 38mmx2.64mm wall CDS Tube or better

Roll bars must be constructed from 38mm x 2.64mm wall tube minimum sizes. 50.8mm material is preffered but not essential.

Roll bars must have small 5mm hole drilled in main hoop in an accessible position to allow for wall thickness to be checked.

Mounting Points for main roll bar and rear back stays must be minimum 100mmx100mm and minimum 3mm thickness

Welding should be to good standard ensuring penetration.

Roll cage padding is required if roll bar is within 150mm of drivers helmet

: